Bcl 4562 Manual 〈2026〉

: The height control unit (BCS100) is often integrated with the BCL 4562 via Ethernet for automated focus management.

Wire a dedicated switching power supply to the main power terminal inputs. bcl 4562 manual

Verify that all terminal block connections are tight and check for stray wire strands. Apply 24V–48V DC power to Terminal Block A. Observe the LED; it should illuminate steady green. : The height control unit (BCS100) is often

The BCL 4562 internal settings are organized into parameter groups. Access them by entering the setup menu via the function key. Parameter Code Description Adjustable Options / Values Baud Rate Selection 1200 / 2400 / 4800 / 9600 (Default) / 19200 P1.2 Serial Output Mode Continuous / Print Mode / Modbus Command Mode P2.1 Digital Filter Strength Apply 24V–48V DC power to Terminal Block A

Measure the board power supply using a digital multimeter. Ensure that voltage across the 24V and 0V rails reads within normal tolerances. Use the diagnostic visualizer tool inside the CypOne software suite to check if the board registers physical transitions from high to low state logic.