La6582p Boardview ^hot^ Full -
Dear Sir,
We have an RDC6445S working in a LaserSaur machine, the cutting file come from RDWorks through USB cable.
If we place a speed of 100 mm/s in RDworks, the file receive by RDC6445S shows on the screen a speed of 100 mm/s, but the working speed is only 100/5 = 20 mm/s.
At the same time, if we tranfer laser head at a 100 mm/s speed (visible on the screen) the head moves at the right speed 100 mm/s.
We tried to update RDC software, but the message is "Bad type mother board etc ..."
Regards,
Richard
La6582p Boardview ^hot^ Full -
When diagnosing a dead board, do not use the original Lenovo brick charger. If there is a severe short, the brick can damage the board further. Use a bench laboratory power supply limited to 1 amp.
Without the exact revision, boardviews may differ (component placements change). la6582p boardview full