If you want to transition to Klipper, the firmware flashing process changes significantly.
Calibrate your heater block and bed to ensure stable temperatures. Use the command M303 E0 S210 C8 in a terminal. two trees sapphire pro firmware upd
Occasionally, a firmware flash can throw off the touch offsets. Keep a stylus or the original "calibration" file handy if the screen becomes unresponsive to touch. If you want to transition to Klipper, the
Below is a you can expand into a formal PDF or internal wiki. Occasionally, a firmware flash can throw off the
settings (stepper currents, travel limits) Klipper installation via Raspberry Pi BlTouch integration wiring and firmware logic Which of these areas should we focus on next?
Unlike Bambu Lab or Prusa printers, Two Trees does not have an "Over-the-Air" update button. You must compile the code yourself (using VS Code and PlatformIO) or find a pre-compiled .bin file from the community. There is no official "support ticket" to help you if it goes wrong.
⚠️ Warning: Do NOT power off during the LED blinking. This corrupts the bootloader.