Simrad Rf300 Installation Manual Page

:

Simrad RF300 Rudder Feedback Unit is a critical component for achieving smooth, accurate steering in inboard-engine autopilot systems. By providing high-resolution data on your rudder's exact angle, it allows your autopilot computer to make precise adjustments that keep you on course. Simrad Yachting Essential Installation Steps simrad rf300 installation manual

If you suspect the unit is failing, disconnect the brown and white wires from the autopilot computer. Connect a digital multimeter set to measure Frequency (Hz) across the two wires while the unit is powered by the system: Should read approximately 3000 Hz. Full Port: Value should rise toward 3400 Hz. Full Starboard: Value should drop toward 2600 Hz. : Simrad RF300 Rudder Feedback Unit is a

Before you even read the first step of the , physically rotate the sensor’s lever arm through its full range. It should move smoothly without any grating or sticking. The spring inside the unit should return the arm to its center position when released. If the arm feels sticky or the spring is weak, return the unit immediately—this is a common failure point that installers sometimes miss. Connect a digital multimeter set to measure Frequency

: For standard Simrad junction units (like the J300X or AC series), connect the Brown wire to Terminal 11 and the White wire to Terminal 12.

Once physically installed, you must digitally configure the sensor via your control unit: B&G RF300 Rudder Feedback Unit | Autopilot - Simrad

Connect the cable shield to the autopilot computer's ground terminal to minimize RF interference. Do not connect the shield at the sensor end. ⚙️ Calibration and Testing